This gallery contains 1 photo.
I’ve finished the bottom of the Fathom playfield swap. I installed new bulb sockets, new drop targets, cleaned every switch, and refurbished every metal bracket and housing. Time: 30 hrs (just for the bottom) Things to note: Many of the … Continue reading
This gallery contains 2 photos.
I did my usual wet sand and polish on this CPR playfield (on left.) Here it is next to the one it’s replacing. I already did some touch up on it before getting the new one. The main difference is … Continue reading
This gallery contains 2 photos.
I got a new CPR playfield for this project. It took two years to locate one because of the rarity of these, but finally I can get this project back on track.
This gallery contains 34 photos.
Here we have a Stern Sharkey’s Shootout from 2000. This game was 100% working, but required a full shop out with new rubber. The playfield was cleaned and waxed. The only playfield touch up was repairing the drop hole near … Continue reading
This gallery contains 1 photo.
The clearcoating went well today. It is tough battling this Florida heat while spraying. My goggles fog up in about 5 minutes. This Playfield is going to look spectacular when it is finished. Time to let it sit awhile before … Continue reading
This gallery contains 1 photo.
Next up…Bally Playboy. Touch up is all done. Time to start the clear coat process. Stay tuned.
This gallery contains 1 photo.
This baby is done! I had to repair another coil and clean most the Playfield switches, but she’s ready to go.
This gallery contains 3 photos.
Finished the whole rack. I found one burned up coil that will have to be replaced. After that, it’s good to go back in the game.
This gallery contains 1 photo.
Time to clean and adjust EVERY switch on this to make it bullet proof. I pulled out the whole rack to make it easier.
